How to Glue Lexus Car Body Side Molding?

Automotive car body molding are decorative, attractive and protective moldings on the whole car body. The term must be applies both to the detail and the material of the molding. Body molding is used to just safe or protect the car body from the scratches and weather condition.




What is Car Molding?


Car moldings include lexus side body molding, lower body molding, perfect door moldings, thin window moldings, footrest molding, best mud flaps, etc. They are frequently found in services in association with lexus floor car mats, plate frame etc.



Various car moldings must have high scratch resistance, weather or storm resistance and gloss matching that of the whole car body. A common material which provides these is called polyvinyl chloride PVC.



Cars or any vehicles come with a lot of options from the factory, but one choice that not every car comes with is lexus best body side molding, which is a plastic, metal or rubber strip, normally about 1 to 3 inches high, that goes down the side of the cars door parallel to the ground. Besides the added styling and appears that can come from side trim, it also can safe or protect the steel of the door from door dings and other damages of cars. Plus, it is very easy to install and only takes a few minutes.




How We Install The Lexus Body Side Molding?


Apply the rubbing alcohol to a paper soft towel and wipe down the side of the vehicle or car where you plan on sticking the best lexus body side molding, making sure the area is very clean and free of dirt and dust.

Apply the rubbing alcohol to a paper towel and wipe down the back side of the car or vehicle molding. Clean off dust and residue on the back of the car panel.

Peel off a section of the double sided best tape and cut it to fit the lexus body side molding.

Stick the best tape to the perfect body side molding by pressing down strongly on the tape. Ensure it adheres to the molding completely before moving on ahead. Peel off the protective layer from the tape and stick the side molding onto the car or any vehicle. Line it up, correctly and exactly, where you want it to be this is a one-time deal. Once it is stuck, it is on there.



0 comments: